ANSYS Fluent Tutorial | CFD Analysis of an Air Heater |Low Reynolds Number , Flow and Heat Transfer Analysis.
ANSYS Fluent Tutorial | CFD Analysis of an Air Heater |Low Reynolds Number flow
In an Air heater, the inlet air temperature is -20 ℃ and the required outlet temperature is 40 ℃. Find out the heat to be generated by the Heater to obtain the hot air at the outlet.
What you will learn from this tutorial?
- Use of Offset option.
- How to set Extrude symmetry in both directions about a plane?
- Fill option to fill a non-axisymmetric geometry by fill by cavity option.
- How to know the volume of any geometry in ANSYS.
- How to know the no of elements and nodes in each body.
- How to setup Boundary conditions for the air heater model.
- How to know the volumetric heat generation rate of the heater.
- Source Term Modeling in ANSYS Fluent.
This tutorial is divided into 2 parts for simplicity.
This is the Part -1 of the tutorial containing the Geometry Creation and Meshing Procedure.
For solver setup and post Processing Please visit the Second part.
Here is the link Part 2: https://youtu.be/Vsl62RqpWFA
You can connect with us on Facebook, Telegram, Instagram, Linked In & Blogger. Please like, share and comment. Subscribe to our channel if have not subscribed yet.
In an Air heater, the inlet air temperature is -20 ℃ and the required outlet temperature is 40 ℃. Find out the heat to be generated by the Heater to obtain the hot air at the outlet.
What you will learn from this tutorial?
- Use of Offset option.
- How to set Extrude symmetry in both directions about a plane?
- Fill option to fill a non-axisymmetric geometry by fill by cavity option.
- How to know the volume of any geometry in ANSYS.
- How to know the no of elements and nodes in each body.
- How to setup Boundary conditions for the air heater model.
- How to know the volumetric heat generation rate of the heater.
- Source Term Modeling in ANSYS Fluent.
This tutorial is divided into 2 parts for simplicity.
This is the Part -1 of the tutorial containing the Geometry Creation and Meshing Procedure.
For solver setup and post Processing Please visit the Second part.
Here is the link Part 2: https://youtu.be/Vsl62RqpWFA
You can connect with us on Facebook, Telegram, Instagram, Linked In & Blogger. Please like, share and comment. Subscribe to our channel if have not subscribed yet.
Comments
Post a Comment
Thank you for your comment.We will reply you soon.